BEFORE INSTALLATION
Confirm that there is enough floor space to install the toliet unit and that the bathroom door will
open/close without obstruction.
Water Pressure. The product is designed to operate with a minimum working pressure of 20psi
INSTALLATION PROCEDURES
1
Install Closet Flange Bolts
Install closet flange bolts in to the
flange channel turning the head of
the bolt 90° and slide in top lace, they
will be spaced 6" (152mm) apart and
parallel to the wall.
4
Position the toilet so the tank will align evenly with the wall, use
a rocking motion and press down firmly on the center of the bowl
pressing it to the floor. Alternately tighten the flange nuts until the
bowl is seated to the floor. Cut flange bolt above the nut and install
the bolt caps. Remove and smooth excess sealant around foot.
Use caution when tightening the
!
nuts as china will break easily!
2
Lay toilet on to its side (use cardboard
to cushion the ceramic and prevent.
damage) Install the wax ring evenly
around the waste flange horn. Place a
bead of sealant on bottom of toilet foot.
Install Toilet
Install Wax Ring Seal
5
Connect the flexible supply line from the stop valve to the
toilet fill valve. DO NOT USE SEALANTS ON SUPPLY FITTINGS!
HAND TIGHTEN the supply line, then open stop valve and
CHECK CLOSELY FOR WATER LEAKS! Adjust the tank water
height to the indication mark on the flush valve tube.
Warranty is
!
void if any type of
sealant is used on
the water supply
connection!
Rubber seal for fill valve
Plastic seal for fill valve
3
Position Toilet on the Flange
Unplug floor waste opening and install the
toilet on to the closet flange aligning the
flange bolts "A" through both mounting
holes on the toilet foot. Loosely install the
bolt cap retainer washer, brass washer and
nut on to the flange bolts "A".
Water Supply Connection
Fill valve head cover
Buoy
Fill valve body
Inlet pipe
Clip
Triangular washer
Fill valve nut
Flush vavle nut
Water-supply pipe
Adjustable rod