Yamaha NX-B150 Manual De Instrucciones página 9

■ To mount the satellite speakers on the wall
You can also mount the satellite speakers on the wall as shown below.
Depending on the mounting direction, you can adjust angles of the
satellite speakers vertically or horizontally.
Wall/
5 mm (13/64 in.)
wall
support
Min. 20 mm
(1-3/16 in.)
Bottom side of
the satellite
Make sure that the screws are securely caught by the narrow
speaker foot
parts of the hole slots.
To adjust angles vertically
(Left) (Right)
41 mm 41 mm
(1-5/8 in.) (1-5/8 in.)
To prevent the satellite speakers from falling, place your other hand on the speaker
foot when adjusting angles.
41 mm (full scale)
To adjust angles horizontally
(Left) (Right)
41 mm 41 mm
(1-5/8 in.) (1-5/8 in.)
1
Prepare 4 commercially available tapping screws 3.5 mm to
4 mm (1/8 in. to 3/16 in.) in diameter.
2
Install 2 screws for the each speaker to a firm wall or wall
support as shown in the illustration on the left.
3
Hang the satellite speakers by their slots onto the
protruding screws.
• Do not mount the satellite speakers on thin plywood or on a wall made of soft
surface material. Otherwise, the screws may pull out of the surface and the
satellite speakers may fall, possibly damaging them or causing personal injury.
• Do not mount the satellite speakers on a wall using nails, adhesives, or unstable
hardware. Long term use and vibration may cause the satellite speakers to fall.
• To avoid accidents resulting from tripping over loose speaker cables, affix the
cables.
• Secure installation is the owner's responsibility. Yamaha shall not be liable for any
accident caused by improper installation.
• If you are uncertain about the wall strength, please consult an installation
specialist.
Speaker placement/connections
9
En