Appendix 1: Flexa Tacto Thermostat Assembly; Appendix 2: Battery Saving Mode - Airzone flexa Manual De Instalación

APPENDIX 1: FLEXA TACTO THERMOSTAT ASSEMBLY

In general, the following considerations must be taken into account for thermostat placing:
• Do not locate the thermostat in places where it will be in direct sunlight (Fig. 16).
• Do not locate the thermostat in air currents (Fig. 17).
• Do not locate the thermostat over sources of heat (Fig. 18).
• Ensure the component is well ventilated.
• It is advisable to locate the thermostat at a height h of between 1.4 and 1.8 metres above
the floor of the room (Fig. 19).
Fig. 43 – Direct sunlight
Fig. 45 – Sources of heat

APPENDIX 2: BATTERY SAVING MODE

This mode allows putting the thermostats in Low Power Mode to remove subsequently the
power supply of the system. To do this, please follow these steps:
1) With the system already associated and fed, put the Master thermostat in OFF.
2) In the Master thermostat press and hold down the On/Off icon until the indication of Low
Battery (Fig. 6) appears in the display.
3) To activate the Battery Saving Mode press on the Airzone icon, select the "SI" (Yes)
option and confirm pressing on the Airzone icon.
To deactivate the Battery Saving Mode, press on each of the thermostats on the indication of
"PULS" to associate the thermostats again.
Fig. 44 – Air currents
h
Fig. 46 – Recommended height
67