Operational Guidelines; Juice Extractor; Preparing For Operation - UFESA PA7000 Manual De Instrucciones

Working with double-sided disc
1
Insert the double-sided disc to the food processor
container applying the side suitable for use (slices / chips).
2
Place the food processor cover so that the pin on
the cover hit the hole in the blade and the symbol
on the cover is aligned with the symbol
container of food processor.
3
Tighten the food processor cover to container
flange and lock it by turning clockwise until the symbol
on the cover is aligned with the symbol
container.
4
Insert the products into food processor hopper and
- if possible - insert the food processor pusher.
5
Turn on the appliance by turning the control knob
to the desired position.
Do not use the appliance with installed
food processor in continuous operation
for more than 30 seconds. After this
time, turn it off and wait 10 minutes before
restarting, allowing the engine to cool down.
● During operation, add the products through the
hopper after removing the food processor pusher. Put
the fruit or vegetables into the hopper of the cover and
lightly press them with pusher.
Do not push products with your fingers
or other objects.
6
To stop the appliance, turn the speed control knob
to "0".
● Open the food processor (blender) in a manner
opposite to that described in paragraphs

Operational guidelines

● Do not crush too large pieces with the food processor
blade. Before loading the container mill (crush) large
products in order to obtain chunks of approximately 3 cm.
● When grinding cheese, butter or margarine do not
allow for too long operation. Processed food may
become hot and dissolve.
● If the product stick to the blade or to the inner walls
of the container, turn off the appliance, remove the cover
and grab the products from blade and container walls.
Double-sided disc – a side applicable to making slices
● You can get regular slices without a scrap when the
appliance is disabled during filling the hopper. You can
either use the "PULSE" to this end.
J
Double-sided disc – a side applicable to making chips
● You can fill the hopper with products while the
appliance is working.
Care and cleaning of appliance with
installed food processor (blender)
on the
Clean the appliance immediately after
use. This will prevent leftovers build-up
on the
inside the food processor.
● After each use, carefully wash the equipment parts
being in contact with the processed product with warm
water plus dishwashing liquid to prevent drying leftovers.
● Wipe the drive housing with a damp cloth with dish
washing liquid.
● Remove the dirt in crevices or corners with bottle-
washing brush or toothbrush.
● Dry thoroughly all parts after cleaning.
● Always store food processor blade in food processor
container.

JUICE EXTRACTOR

Description of the appliance
Your juice extractor is designed for fast fruit and
vegetable juice centrifuging with automatic separation
of pulp. Centrifugation speed was carefully selected
to ensure excellent quality juices. Small particles of
fruit (or vegetable) contained in the extracted juice are
healthy, but may affect the clarity of juice. This is an
3 2 intended effect, as keeping the highest nutrient, health
and .
and dietetic values of your juices is more important
than their clarity. The quantity of juice obtained with
1kg of fruit or vegetables depends on their freshness,
cleanness of the filter and condition of the shredding
disc (e.g. for fresh carrots it is 50-60%). All parts in
contact with processed products are made of materials
suitable for contact with food.

Preparing for operation

Disassembling
Before first use, disassemble the
appliance and wash all parts in contact
with processed fruit or vegetables.
B