Every Six Months - Remington Stylist HC363C Manual Del Usuario

ENGLISH
Then cut the hair against the direction in which it grows and level with the
sides.
• To give a "flat top" look, the hair on top of the head must be cut over the top
of a flat comb.
• Use a closer guide comb to taper the hair down to the neckline as desired.
, TAPER LEVER
• This product has a taper lever located a the left side of the clipper near the
blades. Adjust the lever to change the closeness of the cut gradually and also
to improve the effectiveness of the comb attachments. The taper lever also
extends the life of the blades because a different cutting edge is used in each
setting.
C CARE FOR YOUR HAIRCLIPPER
• Your clipper is fitted with high quality blades.
• To ensure long lasting performance of your clipper, clean the blades and unit
regularly.
• Always keep the attachment guide comb on the trimmer blade.
• Note: Ensure the clipper is turned off when cleaning.

, EVERY SIX MONTHS

• At regular intervals the blade set should be removed and cleaned.
• Remove the 2 screws retaining the fixed blade with a screwdriver. Do not
remove blade set.
• Brush out hairs from between the blades with soft cleaning brush. Do not
remove the lubricating grease from the blades. It is not necessary to remove
the small moving blade from the unit.
• If the moving blade has been removed this can be re-fitted by slotting the
coated blade holder over the pin in the centre of the interior product head.
The groove on the coated blade, just below the teeth, rests on a metal plate at
the opposite side to the screw holes. The fixed blade is fitted with the raised
profile pointing outwards and fixed with the 2 screws.
• Before fully tightening the 2 screws, adjust the taper lever to the lower
position and align the blades so that their cutting edges are parallel to one
another. Tighten the 2 screws.
• If the blades are not correctly aligned, cutting efficiency will be impaired.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe off
excess oil.
• CAUTION: Do not use liquid cleaners on the blades or harsh or corrosive
chemicals on the blade casing. Always use a soft brush to remove the
6