Every Six Months; Cleaning Cautions; Battery Removal - Remington HC5500 Manual De Instrucciones

ENGLISH
• To reattach once the blades are cleaned and dry, align the bottom of the
blade with the bottom blade housing tab and slide the cartridge back into
place until you hear a click.
• Do not run the entire unit under the tap, only the blade set is meant to be
submerged in water.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe off
excess oil.

, EVERY SIX MONTHS

• At regular intervals the blade set should be removed and cleaned.
• Remove the 2 screws retaining the fixed blade with a screwdriver. Do not
remove the blade set.
• Brush out hairs from between the blades with soft cleaning brush. Do not
remove the lubricating grease from the blades. It is not necessary to remove
the small moving blade from the unit.
• If the moving blade has been removed this can be re-fitted by slotting the
coated blade holder over the pin in the centre of the interior product head.
• The groove on the coated blade, just below the teeth, rests on a metal plate
at the opposite side to the screw holes. The fixed blade is fitted with the
raised profile pointing outwards and fixed with the 2 screws.
• If the blades are not correctly aligned, cutting efficiency will be impaired.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe off
excess oil.

, CLEANING CAUTIONS

• Ensure the appliance is switched off and unplugged from the mains before
cleaning.
• Only the attachment guide combs and trimmer blade may be removed from
the product for cleaning.
• Do not rinse under water.
• Do not use harsh or corrosive cleaners on the units or their blades.

BATTERY REMOVAL

• The appliance must be disconnected from the supply mains when removing
the battery.
• Turn the trimmer on and discharge all remaining power.
• Remove the comb attachment.
• Detach the blade cartridge.
• Pry the decorative panel off the top housing to expose the internals and
printed circuit board.
8