Battery Removal - Remington MB4110 Manual Del Usuario

ENGLISH
, REPLACING THE FOILS AND CUTTERS
• To ensure continued high quality performance from your shaver, we
recommend the foils and cutters are replaced regularly.
, Signs that your foils and cutters need replacing
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may
feel the cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.
, TO REPLACE THE FOIL
• Remove the shaving head assembly by pressing the shaver head release
buttons on both sides of the shaver.
• Insert your fingernail between the sides of the foil screen and the head
assembly and pull away from the notches.
• To reassemble, slide the foil into the shaving head and click into position.
• Hold the foil by the plastic frame to prevent damage.
, REPLACING THE CUTTERS
• Remove the shaving head assembly by pressing the shaver head release
buttons on both sides of the shaver.
• Grasp the cutter between your thumb and forefinger and pull upwards.
• Snap the new cutter into the oscillator tip.
, Note: DO NOT press on the cutter ends as this may cause damage.
• Foil and cutter replacement model: SP410

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.
• Ensure the trimmer is discharged of all power.
• With the back side of the trimmer facing upwards, pry the back panel off
the unit to expose the fasteners.
• Remove the 5 screws from the back of the body.
• Pull the top cover off the trimmer.
• Pry the small circuit board at the end of the trimmer out of the body.
• Pry up the main circuit board to expose the batteries.
• Pry the batteries from the trimmer body.
• Cut the leads which connect the batteries to the main circuit board and
dispose of them properly.
7