JBM 53460 Manual Del Usuario página 5

REF. 53460
AIR SUPPLY - GENERAL INFORMATION
Your pneumatic tool complies with EC regulations and will provide you with the level of service you expect
provided you follow the recommendations below. Read them before using a tool and inform all users
thereof.
Start-up
The compressed air network must be perfectly purged and must be suitable for the tool's consumption.
An appropriately sized pressure gauge-regulator and lubricator filter (except for tools designed to be used
without lubrication) must be installed no more than 10 metres upline of the tool. The regulation pressure
should be set to 7.5 bar and the flow rate of special oil, for tools requiring lubrication, must be approx. 1
drop of oil every 30 seconds for an air flow rate if 100 litres/min. Important; the air consumption of your
tool must be greater than the minimum lubrication priming flow rate. A shut-off valve must be placed up
line from the filter.
The tool must be connected to the filter-regulator-lubrication assembly with a special "compressed air" ru-
bber or PVC hose, maximum length 10 metres, minimum internal diameter 8 mm for tools with 1/4" supply
couplings and 12 mm for 3/8" couplings.
Use
Only use accessories in perfect condition and which correspond to the tool's characteristics. Do not modify
the tool in any way in order to use it with accessories for which it is not designed and which have not been
tested by us.
Avoid operating the tool when not under load. Check that no accessories are left fixed to the tool after a
long period of use. Always disconnect the tool when fitting accessories.
Check that accessories are perfectly in place before connecting the tool.
Regularly inspect the condition of the supply pipes. If any damage or leaks are observed, repair immedia-
tely. A burst pipe may result in serious injuries.
Regularly check the lubricator levels and ensure that filters and piping is purged.
Ensure that you are wearing appropriate clothing for the work to be performed. Keep your hands, clothing
and hair away from the rotating end of the tool. Protective goggles and earmuffs must be worn, together
with protective gloves where possible. A mask may also be required for certain work.
Ensure that you stand in a stable, firm position. Pneumatic tools generate high sound levels and may also
generate vibrations depending on the type of work. They must not be used continuously.
Maintenance:
At the start of every day and before stopping use for a long period introduce a few drops of special oil
directly into the inlet port. Do not use flammable liquids such as petrol or diesel fuel.
Regularly check the condition of the regulator filter and the oil level in the air supply lubrication unit.
Check that the supply couplings, piping and accessories are in perfect condition. Regularly purge pipes
and the compressor tank. Do not overlook the compressor's pressure test expiry date.
Only use manufacturer's original parts for maintaining tools.
JBM Campllong S.L. shall not be held responsible for any modifications made to the tools nor for any failure
to observe general safety rules relating to the use of compressed air.
Warranty:
Any warranty is expressly waved in cases of damages arising out of regular wear, overload, handling or
use not suitable for the tool. To be applicable, the tool must be returned. It covers replaced parts and labour
for a period of 12 months from the date of purchase.
Any defect may be removed by replacing the tool or repairing it, as the case may be.
· 5 ·