Craftsman CMEW400 Manual De Instrucciones página 8

CRAFTSMAN accessory attachment location
6
English
Installing/Removing Sanding Sheets
(Fig. E)
A diamond shaped platen uses a hook and loop adhesion
system to attach the sanding sheets. The platen allows you
to use it on large flat surfaces and tight spots or corners.
1. Attach the sanding platen accessory as described under
Installing/Removing Accessories.
2. Align the edges on the sanding sheet with the edge of
the sanding platen and press the sanding sheet onto
the platen.
3. Firmly press the base with the sanding sheet attached
against a flat surface and briefly switch the tool on.
This provides for good adhesion between the platen
and the sanding sheet and also helps to prevent
premature wear.
nOTE: When the tip of the sanding sheet becomes worn,
detach the sheet from the platen, rotate and reapply.
Fig. E
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. F)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the
handle 5 . If extra precision is needed, carefully hold the tool
with both hands.
6
Fig. F
5
Switch (Fig. G)

CAUTION: Because the tool has a separate speed dial
for setting the speed (10000–22000 OPM), the tool
will start at the speed where the variable speed dial is
set. Be sure switch is fully OFF before plugging in the
power cord.
1. Plug in power cord.
2. To turn the tool ON, push the slide switch forward.
3. To turn the tool OFF, push the slide switch backward.
Fig. G
Variable Speed Dial (Fig. H)

CAUTION: Because the tool has a separate speed dial
for setting the speed (10000 - 22000 OPM), the tool
will start at the speed where the variable speed dial is
set. Be sure switch is fully OFF before plugging in the
power cord.
To operate the tool, select the speed setting you wish with
the speed dial, shown in Figure H, and slide the On/Off
switch forward. The speed setting can be adjusted either
with the tool on or off.
The numbered positions,1 through 6 inscribed on the
variable speed dial 2 , do not indicate any precise speed
but are good reference points. The higher the number, the
higher the tool speed.
The approximate speed at each setting is:
sPEED sETTing APPROXiMATE sPEED (OPM)
1
2
3
4
10000
12000
14000
16000