Introduction; Application; Technical Characteristics; Equipment Set - Gauss BT030 Manual Del Usuario

1. INTRODUCTION

The Tester for Automotive Alternators BT030 is
made of high-quality components and material through the
use of advanced techniques of diagnostic equipment ma-
nufacture.
The user manual contains information concerning
BT030 usage, equipment set, design, function, technical
characteristics and operation.
The manufacturer reserves the righ to change the
design and software of the equipment without prior notice
to users.
Read carefully user manual before putting BT030
(hereafter referred to as tester) into use. Take a special
training at the equipment manufacturing facility if neces-
sary.

1. APPLICATION

The equipment
automotive alternators with a supply voltage of 12V in two
ways:
• directly in the car;
• on the diagnostic test bench which provides its drive.

2. TECHNICAL CHARACTERISTICS

GENERAL
Dimensions (L*W*H), mm
Weight, kg
Supply voltage, V
TFT-LCD Touch screen, color
Operating temperature, °C
Storage temperature, °C
Ingress protection rating
ALTERNATOR TESTING
Types of tested alternators
Tested parameters
Supply voltage of tested alternators, V
Polarity reversal protection
Short-circuit sound alert
Battery pack
Tester for Automotive Alternators BT030 Manual
BT030 is designed to diagnose
120x65x18
0,15
from 10 to 18
2.8" screen size
from 0 to +40
from 0 tto +40
IP20
<<COM>> (<<LIN>>, <<BSS>>),
<<SIG>>, <<RLO>>, <<RVC>>,
<<C KOR.>>, <<P-D>>, <<C
JAP>>
- Stabilizing voltage for COM
voltage regulators:
- ID;
- Protocol type
- Exchange rate
- Errors
12
Yes
No
No

3. EQUIPMENT SET

The BT030 tester package includes:
Tester for Automotive Alternators GAUSS BT030 - 1 piece
Set of diagnostic cables:
Four-wire cable - 1 piece;
Cable for connection of additional "+" - 1 piece;
User manual - 1 piece.
Observe the Tester BT030 if any damage is detec-
ted, please contact the manufaturer or sales representati-
ve before launching the equipment.
WARNING! In case of obvious damage, the operation
of the equipment is forbidden.

4. DESCRIPTION

Fig. 1. Tester BT030. General view.
The tester is a compact device supplied with a
touch screen. A connector for diagnostic cable connection
is located in the upper part of the tester (Fig. 2), a MicroSD
connector for software updates - in its lower part (Fig. 3).
Fig. 2. Connector for diagnostic cable.
Fig. 3. MicroSD connector.
Two diagnostic cables are also included in the
equipment set (Fig. 4, 5): a diagnostic cable and an auxi-
liary cable to connect an additional positive contact.
EN
25