Figure 11 Led Array And Connector - Federal Signal Global Serie Instrucciones De Instalación Y Mantenimiento

Installation and Maintenance Instructions
LED ARRAY
Remove the LED Array:
Disconnect power to the beacon.
1.
Use the hexagon key to unscrew the set screw on the housing one full
2.
turn.
Remove the cover from the housing by turning the cover counter-
3.
clockwise. If the cover will not unscrew, back out the set screw a few
additional turns.
Loosen the captive Phillips screw retaining the printed circuit board
4.
(PCB) and slide the PCB out of the housing,
See Figure 11 on page 22. Unplug the J1 connector and remove the
5.
three Phillips screws retaining the LED array to the mounting bracket.
Remove the LED array.
6.
22

Figure 11 LED array and connector

Model G-LED Global Series LED Beacon
J1 CONNECTOR