Replacing The Batteries; Figure 1 Location Of Battery Compartment In Bottom Housing - Federal Signal BPL26L Instrucciones De Instalación Y Mantenimiento

Installation and Maintenance Instructions

Replacing the Batteries

The Model BPL26L is powered by two 6 V spring-terminal
lantern batteries.
To replace the batteries:
1. Open the battery housing by removing the 1/2-inch bolt and
neoprene washer.
2. Bend the upper housing out slightly on each side and pull
the lower housing out.
3. Install the batteries as shown in Figure 1 by standing the
batteries in the bottom housing with the spring terminals
aligned with the + and – symbols on the bottom of the
battery housing.
4. Push the upper housing back onto the lower housing and
replace the neoprene washer and 1/2-inch bolt.

Figure 1 Location of battery compartment in bottom housing

3.59 in
(91.2mm)
6
6.88 in
(174.75 mm)
BOTTOM OF
BATTERY CASE
Battery Powered Warning LED
BATTERIES