Tail Assembly - Rutland FM910-4 El Manual Del Propietario

Rutland Furlmatic 910-4 Windcharger
Fig. 4

Tail Assembly

Fig. 5
Doc No: SM-138 Iss. F 01.10.19
5. Fit the plastic nose dome in position on the
front of the generator hub and secure in place
with the three nylon screws provided. (Fig.4)
Recheck the tightness of all screws in a few
weeks time as loosening is possible.
Alternatively the blades, tail and nose dome
can be fitted after mounting the generator
assembly to the tower.
Fit the tail fin on to the hinge
assembly using the screws and
washers already present (Fig 5)
Do not remove the silicone
protectors from the tail stops!
NB. The tail fin is set at an
angle of 15° from vertical. This
is vital to the furling mechanism
and should not be altered.
For the effective operation of the
furling system the wind turbine
must be sited to ensure it is as
free as possible from turbulence
and the tower is in a stable,
upright position.
9
Installation & Operation
Marlec Eng Co Ltd