Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000343-001.book Page 17 Thursday, September 19, 2019 10:13 AM
Fastening or replacing a grinding
accessory in the wheel arbor
(figure 6).
Hold the spindle in place using an open-end
wrench (size 17 mm) and unscrew the collet
using another open-end wrench
(size 13 mm).
Insert the wheel arbor into the collet.
Note: The maximal allowable protruding shaft
length of the wheel arbor is 5/16 in (8 mm).
Insert the desired tool and tighten the collet
again using the open-end wrench.
Mount the grinding accessory and the disc
onto the wheel arbor.
Lock the collet with the open-end wrench
(size 13 mm) and tighten the hexagon nut
with the open-end wrench (size 17 mm).
Connecting to the power supply.
The power tool is provided ex works without
a plug.
Recommendation: As a protective measure
against overload, equip the power tool with a
matching FEIN motor-protection plug.
The plug is to be installed by a
WARNING
qualified electrician.
Before starting operation,
WARNING
check the rotation direction of
the output shaft without a grinding accessory
mounted, and have it corrected if required.
The rotation direction is marked on the
power tool with an arrow.
Fig. 6
The output voltage and fre-
WARNING
quency of the power supply
must correspond with the data on the type
plate of the power tool.
Using FEIN frequency converters ensures
reliable operation of the power tool.
Follow the steps in the operating instruc-
tions of the frequency converter.
en
17
5/16 in (8 mm)
