OPERATING POLE TRIMMER
Figure 6 - Extension Cord Loop Tight
Around Molded Cord Hook
Note: An optional method of retaining the
extension cord is shown in Figure 7 for use
with larger-gage cords that may not fi t into
the extension cord retainer.
Figure 7 - Optional Method of Retaining
Extension Cord
STARTING THE POLE TRIMMER
The Pole Trimmer has a trigger lock button
located on top of the handle. This safety
feature locks the trigger in the OFF posi-
tion, preventing accidental starting of the
Pole Trimmer.
The trigger lock button has three posi-
tions.
Position 1 locks the trigger.
Position 2 allows you to squeeze the trigger
and operate the Pole Trimmer. The trigger
lock button will automatically spring back to
Position 1 when you release the trigger.
Position 3 allows you to lock the trigger
in the ON position. This is helpful during
continuous trimming for extended periods
of time.
Unlocking the Trigger to Start
the Pole Trimmer
1. Using your thumb, push the trigger lock
button forward to Position 2. Squeeze
the trigger lever to the ON position. The
Pole Trimmer will start running.
Trigger Lock Button
Position 2
Figure 8 - Manually Operating Trigger with
Trigger Lock Button in Position 2
2.
Release the trigger lock button while the
Pole Trimmer is running. The lock button
resets to Position 1 each time you release
the trigger to the OFF position.
Trigger Lock
Button Position
1
Figure 9 - Trigger in OFF Position with
Trigger Lock Button in Position 1
Locking the Pole Trimmer ON
1. Push the trigger lock button forward to
Position 2 and squeeze the trigger lever
to the ON position. The Pole Trimmer
will start running.
2.
While the Pole Trimmer is running, push
the trigger lock button forward again to
Position 3. Hold the button there while
releasing the trigger lever, then release
the lock button. This locks the trigger
lever in the ON position and the Pole
Trimmer will continue running.
3.
To turn the Pole Trimmer OFF, squeeze
the trigger lever and release it. The trig-
ger lock button will reset to Position 1,
locking the trigger in the OFF position.
9
Note: If the Pole Trimmer is locked ON
during use and the Pole Trimmer becomes
disconnected from the power supply, Disen-
gage the lock ON feature before reconnecting
to the power supply.
Trigger Lock
Button Position
3
Figure 10 - Locking Trigger in ON Position
with Trigger Lock Button in Position 3
ADJUSTING POLE LENGTH
The Remington brand Pole Trimmer has a
telescoping pole assembly that has an ex-
tendable range of 10 inches. A cam levered
collet is used to hold the pole in position at
any extended length.
1. To extend the pole, unlock the clamping
lever as shown in Figure 11. Pole will
slide freely.
2. Pull inner pole section out to desired
length of extension.
3.
To lock pole in position, tighten clamping
lever as shown in Figure 11.
UNLOCK
Figure 11 - Extending Telescopic Pole
LOCK