Ratio Pro Serie Manual De Instrucciones página 45

range, the speed will increase and the drill will
have less power and torque.
GEAR I
Low speed range: for screwdriving or working
with large drilling diameter
GEAR II
High speed range: for working with small drilling
diameter
WARNING:To prevent gear damage,
always allow the chuck to come to a
complete stop before changing the direction
of rotation or the two-speed gear control.
F
6. CHUCK ADJUSTMENT (SEE FIG. G)
To open the chuck jaws rotate the front section of
the chuck. Insert the drill bit between the chuck
jaws and rotate the front section in the opposite
direction. Ensure the drill bit is in the center of
the chuck jaws. Finally, firmly rotate the front
chuck section in the opposite directions. Your drill
bit is now clamped in the chuck.
G
7. TORQUE ADJUSTMENT (SEE FIG. H)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque
adjustment ring. The torque is greater when the
torque adjustment ring is set on a higher setting.
The torque is less when the torque adjustment
ring is set on a lower setting.
When drilling in masonry and concrete choose
the hammer position .
When drilling in wood, metal, plastic and
screwdriver choose the drill position
Make the setting as follows:
1 - 4 for driving small screws
5 - 9 for driving screws into soft material
10 - 14 for driving screws into soft and hard
material
15 - 21 for driving screws into hard wood
22 for driving larger screws
for heavy drilling
for drilling in masonry and concrete
H
8. USING THE SIGHT LIGHT
To turn on the light, press the on/off switch and
make sure the forward/reverse rotation control is
on right/left position. When you release the on/off
switch, the light will be off.
LED lighting increases visibility-great for dark or
enclosed area.
9. BATTERY CAPACITY INDICATOR
Your tool is equipped with battery capacity
indicator (11). Press the on/off switch halfway or
fully, the battery capacity indicator will light up to
show the amount of charge left in the battery.
Fuel Gauge
3 green lights
2 green lights
1 green light
1 flashing light
10. BELT HOOK (SEE FIG. I)
Screw the Belt clip on the tool with the screw.
The Belt clip can be hooked on your belt or
pocket, etc.
.
Capacity
> 2/3
> 1/3
< 1/3
reserve
45