Promaker PRO-H2000 Manual Del Usuario página 3

Never touch the mains plug and the socket with wet hands.
Check the power cord with mains Plug for damage prior to every use.
Do not operate an appliance if the power cord is damaged.
All current-conducting parts in the working area must be protected
against jet water.The mains plug and the coupling of an extension
cable must be watertight and must never lie in water. Moreover, the
coupling may never lie on the ground. The use of cable reels that
ensure that the sockets are at least 60 mm above the ground is
commended.
Make sure that the power cord or extension cable is not damaged by
running over, pinching, dragging or the like. Protect the power cords
from heat, oil, and sharp edges.
Turn off the appliance and remove the mains plug prior to any care and
maintenance works.
Repair work and work on the electrical components may only be
performed by an authorized customer service.
WARNING
The appliance may only be connected to an electric supply that has
been installed by an electrician in accordance with IEC 60364.
The appliance may only be connected to alternate current. The voltage
must correspond with the type plate of the appliance.
Safety class I appliances may only be connected to sockets with
proper earthling.
For safety reasons, we recommend that you operate the appliance
only via a residual current device (max. 30mA).
An unsuitable electrical extension cable can be hazardous. Only use
an electrical extension cable which has been approved and labeled for
this purpose and has an adequate cable cross-section outdoors: 1 - 10
m: 1.5 mm ;10 - 30 m: 2.5 mm
2 2
Always fully unreel the extension cable from the cable drum.
3