Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Then, slide the hose on and twist counter-clockwise
to secure.
3. To remove, twist the hose clockwise and slide hose off.
Fig. C
20
12
nOTE: Many inflatables have an internal flap that prevents
air loss during inflation, especially air mattresses. Unless this
flap is displaced by the nozzle the inflatable will not inflate.
Push the nozzle firmly into the valve to make sure that you
push this flap out of the way.
WARNING: Risk of Bursting. Excessive air pressure
may cause a hazardous risk of bursting or personal
injury. Check the manufacturer's maximum pressure
rating for items being inflated.
nOTE: If the pressure rating for the item being inflated
is above 100 p.s.i.g., note that the maximum run time is
10 minutes, leave to rest for 20 minutes before reusing.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. D)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
21
battery pack with the rails inside inflator's battery port
and slide it into the port until the battery pack is firmly
seated and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
and firmly pull the battery pack out of the tool
23
handle. Insert it into the charger as described in the charger
section of this manual.
7
19
into the inflator, align the
22
Fig. D
Switching On (Fig. A, E)
WARNING: Risk of Bursting. Do not leave unit
running unattended. Overinflation of tires and
other items could result in serious injury and
property damage.
nOTE: When power is supplied to the inflator by 12V, 20V
battery, or 120V AC the digital readout display will remain
on for approximately 10 minutes before the display shuts
off/goes into sleep mode. This occurs when the unit is not
operating. To wake up the system, the user will need to
push the pressure mode / reset button
digital readout will turn on and the inflator is ready for use.
Before switching your inflator on, decide which power
source you will be using; 12V AC adapter, 120V AC plug or a
20V Max* battery pack.
•
To use the 12V AC adapter, or 20V Max* battery pack
press the AC/DC power switch
the unit to DC.
-
If using the 12V AC vehicle adapter
extend the 12V AC cord before each use.
-
Connect the 12V AC vehicle adapter
vehicles 12V AC accessory socket.
•
To use the 120V AC cord, press the AC/DC switch
located on the front of the unit to AC.
-
If using the 120V AC cord
the cord before each use.
-
Connect the 120V AC cord
outlet or an approapriate sized extension cord that
is plugged into a wall outlet.
English
23
21
22
. At this time the
5
located on the front of
1
14
, always fully
14
into your
1
13
, always fully extend
13
into either a wall
9
Tabla de contenido
