Technical Data; Assembly & Operation - Worx WG607 Manual Del Usuario

TECHNICAL DATA

Rated current
Rated pressure
Rated water flow rate
Soap tank capacity
Power cord length
Machinery weight
Max water temperature
Maximum inlet pressure
Protection class
ACCESSORIES
Nozzle (25° / 40° / soap )
Turbo Nozzle
10
25ft Hose
Declogging needle
We recommend that you purchase your accessories listed
in the above list from the same store that sold you the tool.
Refer to the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The electric high pressure washer is intended for residen-
tial cleaning projects-from porch to patio, driveways and
decks, boats, pavers, bricks, BBQs and more.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Electric Pressure Washer
WG607
13 A
2000 psi (138 bar)
1.2 gpm
0.5 Gal (1.9 L)
35 ft (10.5 m)
41.2 lbs (18.7 kg)
104 °F (40°C)
80 psi (0.55 MPa)
I
WG607
3
1
1
1
FIGURE
Cart Handle assembly
NOTE: when you hear "click ",it
means that the handle has been as-
sembled successfully.
Attaching the lance
NOTE: Hold the lance with one hand
and rotate the clamping lever until it
is tightened.
Screwing & Unscrewing the high pres-
sure hose
NOTE: Make sure the hose is tightly
connected.
NOTE: For convenience of unscrewing
the hose, please pull the trigger to drain
water from wand when operation is
completed and on/off switch is in "O"
position.
Attaching the garden hose
Connect one end of the home garden
hose (not supplied) to the connector
and another end to waterspout.
OPERATION
Extension cord
It is not recommended to use the
extension cord. If necessary, ensure
the plug and extension cord con-
nection is on an elevated surface
that does not contact the water
area.
GFCI plug test
Press "test", the light will be out.
Press "reset", the power regains and the
light will illuminate.
NOTE: To keep good operation of
GFCI, please implement it once a
month.
Start/stop
Turn on the water supply tap. Connect
the washer to the power supply and
turn the on/off switch to "I " position.
Then press trigger.
NOTE: Before pressing trigger, push
the lock-out down into the trigger.
WARNING: Do not start the
machine without connecting
and turning on the water supply
because it may cause damage to
high pressure seals and reduce the
service life of pump.
See Fig. A
See Fig. B
See Fig. C1,
C2, C3, C4
See Fig. D
See Fig. E
See Fig. F
See Fig. G1,
G2
EN