Technical Data - Worx HYDROSHOT WP650 Manual De Instrucciones

8. ADAPTER
9. HOSE
10. 5L TANK
11. SHOULDER STRAP
* Not all the accessories illustrated or described are
included in standard delivery.

TECHNICAL DATA

Voltage
Rated Water Flow Rate
Max Water
Temperature
Machine Weight
**Voltage measured without workload. Initial battery voltage
reaches maximum of 20 volts. Nominal voltage is 18 volts.
ACCESSORIES
WP650 WP650.9 WP651 WP651.9
Spray nozzle and
1
short lance kit
Extension lance 1
Battery pack
1
(WA3575)
Charger
1
(WA3881)
1L Bottle 1
5L Tank /
Shoulder strap /
Only use the appropriate accessories intended for this
tool. Accessory information can be found on the product
packaging, at a Worx dealer or on our website at www.
worx.com.
20V Sanitizing pressure washer
WP650 WP650.9
WP651 WP651.9
20 V Max.**
8 L/h
122 °F (50 °C)
3.7 lbs (1.7 kg) 2.7 lbs (1.2 kg)
1 1 1
1 1 1
/ 1
/ 1
1 /
/ 1 1
/ 1 1
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
ASSEMBLY & OPERATION
BEFORE OPERATION
Installing the battery pack
Removing the battery pack
Checking the battery condition
NOTE: Fig. A3 only applies for the battery
pack with battery indicator light.
Charging the battery pack
OPERATION
NOTE: The power nozzle has two working
modes: spray nozzle and short lance kit
only; spray nozzle and short lance kit used
together with extension lance.
Working mode 1
Attaching spray nozzle and short lance kit
to the sprayer
Working mode 2
Attaching extension lance to the sprayer
Attaching spray nozzle and short lance kit to
the extension lance
Filling the tank
When adding spray solutions, you may add
water and the desired chemical solution
directly into the tank, or use a solution that
has been premixed in a separate container,
then poured into the sprayer.
NOTE:
If you use solid or powder
chemicals, mix them with water
completely to avoid clogging the spray
/
nozzle.
WARNING: Do not overfill the tank.
Chemicals used must be as thin as water.
/
Thicker chemicals will not spray properly.
WARNING: Before filling the tank, always
/
remove the battery pack. Wipe up any
spills before inserting the battery pack.
NOTE: Chemicals should be stored out of
the reach of children. Failure to do so may
result in serious personal injury.
Attaching the hose adapter to the 1L bottle
(only for WP650)
NOTE: Remove tank and fill away from
sprayer. Clean the exterior of the tank and
clean up any spillage before replacing
tank.
Attaching the hose adapter to the sprayer
ACTION FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. A4
See Fig. B
See Fig. C1,
C2
9
See Fig. D1,
D2, D3
See Fig. E
See Fig. F1,
F2, F3
EN