3. Ceiling Fan Assembly
3.12
Loosen the Two Set Screws in the Motor Coupler .
Place the 4 .5" Downrod into the Motor Coupler, aligning
the Clevis Pin Holes in the Downrod with the Holes in
the Motor Coupler (Figure 12) .
The Clevis Pin must go through the Holes in the Motor
Coupler and the Holes in the Downrod .
Be sure to push the Straight Leg of the Hairpin Clip
through the Hole near the end of the Clevis Pin until
the Curved Portion of the Hairpin Clip snaps around the
Clevis Pin .
The Hairpin Clip must be properly installed to prevent
the Clevis Pin from working loose .
Pull on the Downrod to make sure the Clevis Pin is
properly installed .
WARNING
!
It is critical that the clevis pin in the motor coupler
is properly installed. Failure to verify that the pin is
properly installed could result in the fan falling.
3.13
While pulling up on the 4 .5" Downrod, retighten the Two
Set Screws (previously loosened) in the Motor Coupler
to secure the Downrod into place (Figure 13) .
NOTE: The set screws must be properly installed as
described above, or fan wobble could result.
WARNING
!
It is critical that the set screws are securely tightened.
Failure to verify that the set screws are properly
installed could result in the fan falling.
(Continued)
4.5"
DOWNROD
CLEVIS
PIN
MOTOR
MOTOR
COUPLING
COUPLER
Figure 12
4.5" DOWNROD
MOTOR
MOTOR
COUPLER
COUPLING
RETIGHTEN
RETIGHTEN
SETSCREWS
SET SCREW
Figure 13
Please contact 1-800-777-4440 for further assistance
9
HAIRPIN
CLIP
CLEVIS
PIN
HAIRPIN
CLIP
LOOSEN
LOOSEN
SET SCREWS (2)
SETSCREWS (2)
RETIGHTEN
RETIGHTEN
SETSCREWS
SET SCREW
luminancebrands.com
U.L. Model No.: CF784-3