Wall Control Installation - Luminance Brands Kathy Ireland Home ION ECO CF5300BS00 El Manual Del Propietario

WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box or circuit breaker panel before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
CAUTION
!
To reduce the risk of electrical shock, disconnect the
electrical supply circuit before installing the fan, light
kit or receiver.
9.2
N O T E : E l e c t r i c c o n n e c t i o n s s h o u l d b e i n
accordance with the National Electrical Codes and
all Local Codes. Before starting, disconnect power
to the circuit at the main fuse box or circuit breaker
panel.
Remove the Faceplate and Screws from the Existing
Wall Switch . Pull Switch out from Wall Box (Figure 32) .
Determine the "HOT" Wire and the "LOAD" Wire and
disconnect these Wires from Existing Wall Switch .
NOTE: Do not attempt to disconnect any Wires not
already connected to Existing Wall Switch.

9. Wall Control Installation

NOTE: Make all wiring connections using
Wire Connectors (supplied). Make sure that all
connections are tight, including ground, and that no
bare wire is visible at the wire connectors, except
for the ground wire.
9.1
Disconnect Electrical Power to the Branch Circuit at
the Circuit Breaker Panel or Main Fuse Box before
attempting to install the Ceiling Fan Wall Control into the
Wall Box .
SCREWS
Figure 32
Please contact 1-800-777-4440 for further assistance
21
WALL
WALL
BOX
SWITCH
FACEPLATE
luminancebrands.com
U.L. Model No.: CF5300