Wall Control Installation - Luminance Brands Kathy Ireland Home HF1161BQ00 El Manual Del Propietario

CAUTION
!
The included wall control is ONLY designed to operate
the HF1161. It cannot be used to control any other DC
or AC fan.
The wall control is rated to operate up to 3 HF1161 DC
fans at once. Using more than 3 fans will damage the
control.
SINGLE-POLE INSTALLATION
CAUTION: To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the fan or receiver.
NOTE: Make all wiring connections using
wire connectors (supplied). Make sure that all
connections are tight, including ground, and that no
bare wire is visible at the wire connectors, except
for the ground wire.
7.1
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to install
the Industrial Fan Wall Control into the Wall Box.
Remove Faceplate and Screws from Existing Wall
Switch (Figure 26).
Pull the Wall Switch out from the Wall Box (Figure 26).
7.2
Remove the Wire Connector of the Existing Wall
Switch Black Wire from the Wall Box Black "HOT" Wire
(Figure 27).
Remove the Wire Connector of the Existing Wall Switch
Black Wire from the Wall Box Black "LOAD" Wire
(Figure 27).
NOTE: Do not attempt to disconnect any Wires not
already connected to Existing Wall Switch.

7. Wall Control Installation

!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse or circuit breaker box before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
WALL BOX
EXISTING WALL
SWITCH
SCREWS (2)
Figure 26
EXISTING
WALL CONTROL
HOT BLK
GND
NEUTRAL
RECEIVER LOCATED WITHIN
THE CEILING COVER
WlALL BOX WIRES
EXISTING WALL SWITCH
BLACK WIRES
Figure 27
16
WARNING
SCREWS (2)
FACEPLATE
BLACK
GROUND
ETL Model No.: HF1161