General Safety Precautions - Roger Technology H70/200AC Instrucciones Y Advertencias Para El Instalador

1

General safety precautions

WARNING: IMPORTANT SAFETY INSTRUCTIONS
THESE INSTRUCTIONS MUST BE FOLLOWED TO GUARANTEE THE SAFETY
Failure to observe the information included in this manual may result in
personal injury or damage to the equipment.
ROGER TECHNOLOGY cannot be held responsible for any damage or injury due to
improper use or any use other than the intended usage indicated in this manual.
The installation, electrical connections and adjustments must be performed by
applicable regulations.
Read the instructions carefully before installing the product.
Incorrect installation may pose risks.
gas or vapours constitute serious danger for safety.
precautions and to the protection or segregation of areas involving crushing,
shearing, dragging risks or any other risks.
ROGER TECHNOLOGY is not liable for failure to observe the good practices in the
use.
The safety devices (photocells, sensing edges, emergency stops, etc.) must be
force, the good practices criteria, the installation environment, the operating logic
of the system and the forces generated by the motorised door or gate.
The safety devices must protect any areas where there is crushing, shearing,
dragging or any other danger in general generated by the motorised door or gate;
the installer is advised to check that the moving wings do not have sharp edges or
anything that may pose shearing and/or dragging risks.
If it is deemed necessary based on the risk analysis, install sensing edges on the
mobile part.
It should be noted that, as provided by the UNI EN 12635 standard, all requirements
checked.
OF THE PERSONS
PRESERVE THESE INSTRUCTIONS
45