Installing Your Appliance; Cabinet Clearances - AGA marvel ML15WSG2 Serie Instrucciones De Instalación, Operación Y Mantenimiento

!
WARNING
WARNING - Help Prevent Tragedies
Child entrapment and suffocation are not problems
of the past. Junked or abandoned refrigerators are
still dangerous - even if they sit out for "just a few
hours".
If you are getting rid of your old refrigerator, please
follow the instructions below to help prevent
accidents.
Before you throw away your old refrigerator or
freezer:
•
Take off the doors or remove the drawers.
•
Leave the shelves in place so children may not
easily climb inside.
Select Location
The proper location will ensure peak performance of
your appliance. We recommend a location where the
unit will be out of direct sunlight and away from heat
sources. To ensure your product performs to
specifications, the recommended installation location
temperature range is from 55 to 100°F (13 to 38°C).
Cabinet Clearance
Ventilation is required from the bottom front of the
appliance. Keep this area open and clear of any
obstructions. Adjacent cabinets and counter top can be
installed around the appliance as long as the front grille
remains unobstructed. Overlay door models with
articulated hinges are intended for built-in applications
only.
!
WARNING
An optional stacking kit is required to stack products.
Failure to use a stacking kit could result in personal
injury. Contact your dealer or Aga Marvel customer
service at 800-223-3900 to order.

INSTALLING YOUR APPLIANCE

4
!
CAUTION
Front Grille
Do not obstruct the front grille. The openings within the
front grille allow air to flow through the condenser heat
exchanger. Restrictions to this air flow will result in
increased energy usage and loss of cooling capacity.
For this reason it is important this area not be
obstructed and the grille openings kept clean. AGA
MARVEL does not recommend the use of a custom
made grille as air flow may be restricted. (See Figure
2).
Leveling Legs
Adjustable legs at the front and rear corners of the
appliance should be set so the unit is firmly positioned
on the floor and level from side to side and front to
back. The overall height of your Marvel appliance may
be adjusted higher (by turning the leveling leg out,
CCW) and lower (by turning the leveling leg in, CW)
dimensions as shown in Table "A".
To adjust the leveling legs, place the appliance on a
solid surface and protect the floor beneath the legs to