Timer: Acoustic Signal Only; Keypad Lock - Fulgor Milano FPH G Serie Instalación, Uso, Mantenimiento

EN
Programming
Press the ON/OFF button. In the upper part
of the button the LED indicating activation will
light up.
In the control panel, where the zones of each
burner are represented, press the button
corresponding to the zone for which the
automatic switch-off is to be set; the burner
indicator (LED) will start to flash to signal that
the burner is currently ready for programming
while the timer display will show 0.00.
With the + / - keys it is possible to set the time,
with 30-second steps from 1 to 10 minutes and
with 1-minute steps from 11 up to a maximum
of 240 minutes.
The selected burner is identified by the
corresponding LED indicator in flashing mode.
To select the desired area, with displaying
of the relative time on the display, press the
corresponding button.
Cancellation
During the time programming it is possible to
reset the current setting at any time by pressing
for 5 seconds the button corresponding to the
burner which is to be reset, (a time equal to
zero deactivates the burner timer).
It will also be possible to simultaneousness
reset all the timings by pressing the ON/OFF
button for 5 seconds.

TIMER: Acoustic signal only

With the device it is also possible to set the
timer function; this function has no influence
on the operation of the burners.
Programming
Press the ON/OFF button. In the upper part
of the button the LED indicating activation will
light up.
Press the timer button. The indicator (LED) will
start to flash to indicate that it is currently ready
for programming and the display will show
0.00.
With the + / - keys it is possible to set the time,
with 30-second steps from 1 to 10 minutes and
with 1-minute steps from 11 up to a maximum
of 240 minutes.
4
If the timer is selected, it is identified by the
relative LED indicator in flashing mode.
display the time on the display, press the timer
button.
Cancellation
During operation it is possible at any time to
reset the current setting by pressing the timer
button for 5 seconds (a time equal to zero
deactivates the function).

Keypad lock

Once a timer auto-off or timer function is set,
the keypad can be locked by pressing only
once the ON/OFF button. The previously
entered settings will be retained and it will not
be possible to change them until the ON/OFF
button is re-enabled.
To