EMKO EZM-XX50 Serie Manual Del Usuario página 8

Parameter Definitions
:Input Types and Functions
0 : Upcount on rising edge of Ch-A input
1 : Down count on rising edge of Ch-A input
2 : Upcount on rising edge of Ch-A input
3 : Upcount on rising edge of Ch-A input,Upcount on rising edge of
Ch-B input . (INC/INC)
4 : Upcount on rising edge of Ch-A input when Ch-B is at 0 Downcount on rising edge of Ch-A
when Ch-B is at 1
5 : x1 Phase Shifting
6 : x2 Phase Shifting
7 : x4 Phase Shifting
: Selection of Input Type Function for Chronometer
0 : Period measurement in Ch-A input
1 : Pulse time measurement in Ch-A input
2 : Sum of the time difference between Ch-A and Ch-B inputs rising edges
: Selection of Measuring Method
0 : Frequency or cycle is calculated by measuring cycle time of the signals in Ch-A input
1 : Frequency or cycle is calculated by counting the pulses in Ch-A input during the time
is set in measurement period.
: Pulse Time of Ch-A, Ch-B, Reset and Pause Input
It is used to protect against the electrical contact debounce or the signal that is less than
the determined pulse time.
It can be adjusted from
: Selection of Time Unit and Scale
Hour / Minute It can be adjusted from
Minute / Second .
Second / milisecond.
Hour / Minute It can be adjusted from
Hour. It can be adjusted from
Minute. It can be adjusted from
Second. It can be adjusted from
: Output Functions
0: Manual Reset-1:
Device continues to count till manual reset
is applied. When count value reaches the
Set value, output position is changed.
. (INC)
,Down
.(UP/DOWN)
.(For Incremental Encoder )
.(For Incremental Encoder )
.(For Incremental Encoder )
.
to
.
It can be adjusted from
It can be adjusted from
.
. (DEC)
count on rising edge of Ch-B input
.
millisecond.
0 to 99.59.
0 to 99.59.
0 to 99.99.
0 to 23.59.
0 to 999.99.
0 to 999.99.
0 to 999.99.
Reset
Set2
Set1
0
Out-1
Out-1
Out-2
.(INC/DEC)
.
.
=
=
=
=
8