EMKO EZM-XX50 Serie Manual Del Usuario página 14

Failure Messages in EZM-XX50 Timer & Counter
S2
TOTAL RESET
SET1 SET2
2- If the password is not 0, user can access to the parameters
without entering the password and by pressing ENTER button.
Main Operation
Screen
S2
TOTAL RESET
SET1
SET2
W h e n P R O G
button is pressed,
password entering
screen will appear.
Main Operation
Screen
S2
TOTAL RESET
SET1 SET2
O1
O2
S1
S2
TOTAL RESET
SET1 SET2
O1
O2
S1
S2
TOTAL RESET
SET1
SET2
1- Position of the DIP Switch is wrong. (DIP Switch
determines the operation function of the device
and it is under the top cover.)
Password Screen
TOTAL RESET
SET1 SET2
Press ENTER By pressing ENTER
Button without button, user can
entering the see all parameters
password. except for program
password.
Input Types and
Functions
TOTAL RESET
SET1
SET2
3- If Actual Value is flashing and counting is stopped;
It appears if any of the count value is bigger than
the maximum count value.(Total count value for
Counter/"Totalizer Counter"
Function - Batch count value for Batch Counter
FUNCTION )
To remove this warning and reset the count value
press RESET button.
4- If actual value is flashing and counting is not
performed;
It appears if any of the count value is less than the
minimum count value.
(Total count value for Counter/"Totalizer Counter"
Function - Batch count value for Batch Counter
FUNCTION )To remove this warning and reset the
count value press RESET button.
Input Types and
Functions
TOTAL RESET
SET1 SET1
SET2
Press PROG
button to exit
from
programming
mode.
Multiplication
Coefficient
TOTAL RESET
SET2
Continue to
Press ENTER
button for
scanning the
parameters.
14