EMKO EZM-XX50 Serie Manual Del Usuario página 12

: Output-2 Pulse Time
It determines how long Output-2 will be active.
0099.99 seconds.
: Start of the Controlling
Control is started when the unit is energised.
Control is started when count value reaches to SET1 value
Control is started when count value reaches to SET2 value
: Direction of Counting
Upcount. ( 0 --> Preset )
Downcount. ( Preset --> 0 )
: Point position for the Display
No point.
Between first and second digits.
Between second and third digits.
Between third and fourth digits.
Between fourth and fifth digits.
: Saving Count Value
Count value is saved to memory when power is disconnected and restored on
power up.
Count value is not saved to memory when power is disconnected.
: SET1 Operation Form Selection
Absolute operation.SET1 can be adjusted from
Operation with offset. SET1 can be defined ± Offset
according to SET2 value.( SET1 = SET1 + SET2 )
: Communication Accessing Address
Device address for serial communication bus.
to .
: Modbus Protocol Type Selection
Modbus ASCII protocol is selected.
Modbus RTU protocol is selected.
: Communication Parity Selection
No Parity .
Odd Parity.
Even Parity.
It can be adjusted from
.
to
It can be adjusted from
0000.00 to
.
.
12