ATTACH THE FIRST RAMP SECTION
Note: Use the optional SICO
save time and effort.
1. Move the loaded ramp caddy to near
where the ramp section will be set up.
Lock the caddy casters to keep the
caddy from moving while unloading the
ramp sections.
2. Ramps with three or more sections will
have at least one section with folding
legs. The ramp section with the
longest legs is the first section to install.
3. With the ramp section on the caddy,
release the leg brace locking pins by
rotating the two yellow handles until the
handles are perpendicular to the legs.
See Figure 1.
4. Partially extend the legs as shown in
Figure 2.
5. Rotate the yellow handles to their
original position.
6. Swing the legs fully out until both
locking pins engage in the leg braces.
7. While holding the ramp section in
place, lift the lock on the caddy to
release the deck.
See Figure 3.
8. Rotate the deck until one of the legs
contacts the floor.
9. With one person at each end of the
ramp section, pivot the ramp off the
caddy so that is rests on its legs and
the upper attachment brackets.
See Figure 4.
®
caddies to
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
PAGE 8