Jacuzzi city spa Manual De Instalación página 37

Water leakage from shaft
of the pump (rotating joint
between the pump and the motor)
he motor does not start
T
The motor stops
*
: This type of repair requires the intervention of qualified personnel.
For all extraordinary maintenance we recommend that you contact an authorised Jacuzzi® service centre and provide, when
requested, the product serial number (found on the warranty certificate).
It is the responsibility of the installer/owner to ascertain compliance with specific local regulations prior to installation. Jacuz-
zi Europe S.p.A. gives no guarantee in this respect and declines all responsibility regarding the compliance of the installation
performed.
Motor bearings worn or faulty
The impeller rubs against the pump body
Solid bodies in the pump
Pump mechanical seal worn or defective
No power
Main switch has tripped
Voltage too low
Circuit breaker has tripped
Incorrect or faulty connections
Shaft and impeller blocked
Motor windings burnt
Faulty contact on motor
start-up
Water level too low
(the display presents "LL" and the spotlight flashes)
The function has ended
Overload
Power supply cables not suitable
Water level too low
(the display presents "LL" and the spotlight flashes)
The "Silence" function has been activated
37
*
*
*
*
Turn on the mains switch
Turn on switch
Contact an electrician or the organization
that provides electricity
Reset breaker
*
*
*
*
Add water up to the level indicated
in the chapter "Check operations"
Press the key again
Let the motor cool,
the problem should disappear.
If it persists, see *
Consult an electrician
Add water up to the level indicated
in the chapter "Check operations"
See the chapter "Utility functions -
"Silence" function