Rola Adventure System Manual Del Usuario página 4

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Please read all instructions carefully before assembly, installation and/or use of this product.
To secure the wiring harness to the Swing-Away frame, remove the Bail Lock Pin from and lift up on latch
4
handle and open up the Swing-Away frame until it stops.
WARNING: Always keep hands and fingers away from latch mechanism and hinge while
operating the Swing-Away. Starting from one end, place the wiring harness along the bottom surface
of the main support and attach using the six cable ties supplied. For best results, the cable ties should be
equally spaced as shown. Note: Be sure to locate the correct end of wiring harness as indicated in the
diagram below.
For Swing-Away
MODELS ONLY
Remove the Bumper Pack (some models) from the Cargo Tray by opening the two latches that secure
5
the Cargo Tray to the Bumper Pack.
Rotate the Bumper Pack up as shown and pull it away from Cargo Tray.
6
Install the bail pins into the holes with the support brackets in the folded down position.
For Tilt-Up
MODELS ONLY
Cequent Consumer Products, Inc.
Solon, OH 44139 USA
Cequent Help Hotline: 1-800-234-6992
Latch
Vehicle side
4-way flat
(3 Prong Male End)
Cargo Tray to Bumper
Pack Latches
INSERT BAIL PINS
Adventure System
Product Name:
Product Code:
Wiring Harness
Cable Tie - 6 Places
Page 4 of 27
59109 / 59110
Accessory side
4-way flat
Bail Lock Pin
www.rolaproducts.com
(T258) 112816
10-18-05 Rev A
Tabla de contenido
loading

Este manual también es adecuado para:

5910959110

Tabla de contenido