Rola Adventure System Manual Del Usuario página 3

Please read all instructions carefully before assembly, installation and/or use of this product.
Attach the support brackets to the Tilt-Up MAIN SUPPORT assembly. Install the 3/8" x 1.25" cap screw through
3A
the INNER hole in bracket with the flat washer placed between the bracket and the hinge plate on MAIN
SUPPORT assembly. Install 3/8" lock nut on cap screw and tighten until snug. Repeat for other support bracket.
NOTE: Attach support brackets with the flanges to the inside as shown.
FLAT WASHER IS
SANDWICHED BETWEEN
THE SUPPORT BRACKET
AND HINGE PLATE
3B
Attach the support brackets to the Swing-Away MAIN SUPPORT assembly. Install the 3/8" x 1.25" hex bolts, flat
washers, lock washers and hex nuts through the holes in support bracket and into the holes in plates on the
MAIN SUPPORT assembly. Repeat for other support bracket. NOTE: Attach support brackets with the flanges
to the inside as shown.
3/8" x 1.25 HEX BOLT
3/8" FLAT WASHER
3/8" LOCK WASHER
3/8" LOCK NUT
BOTH SIDES
SUPPORT
BRACKET
BRACKET FLANGES TOWARD
THE INSIDE AS SHOWN
Cequent Consumer Products, Inc.
Solon, OH 44139 USA
Cequent Help Hotline: 1-800-234-6992
MAIN SUPPORT
ASSEMBLY
BRACKET FLANGES TOWARD
THE INSIDE AS SHOWN
SUPPORT BRACKET
Tighten 3/8" hex bolts to 30 ft-lb.
MAIN SUPPORT
Adventure System
Product Name:
Product Code:
HINGE PLATE 5/8" PIN
ASSEMBLY
Page 3 of 27
59109 / 59110
Tilt-Up Model
SPRING CLIP
INNER HOLE TO
ATTACH BRACKET
HOLE FOR BAIL
LOCK PIN
3/8" x 1.25 CAP SCREW
3/8" FLAT WASHER
3/8" LOCK NUT
Swing-Away Model
5/8" PIN
www.rolaproducts.com
(T258) 112816
SPRING CLIP
10-18-05 Rev A