Kalmar THE OTTAWA T2 Manual Del Operador página 56

Preventative Maintenance Form
KALMAR TERMINAL TRACTOR PREVENTATIVE MAINTENANCE FORM
NON-SYNTHETIC (NON – TES-295) LUBE USED IN THE TRANSMISSION
TRUCK NUMBER LOCATION
EACH OF THE FOLLOWING ITEMS SHOULD BE CHECKED AND THE CORRESPONDING BOX MARKED WITH THE APPROPRIATE NOTATION.
√ = SATISFACTORY
"A" INSPECTIONS SHOULD BE PERFORMED AT 250 HOUR INTERVALS, "B" INSPECTIONS AT 500 HOUR INTERVALS, "C" INSPECTIONS AT 1000 HOUR
INTERVALS, AND "D" INSPECTIONS AT 2000 HOUR INTERVALS.
OPERATION
CAB – INTERIOR
CHECK OPERATION OF NEUTRAL START
CHECK OPERATION OF ALL GAUGES
CHECK LOW AIR BUZZER AND LIGHT
CHECK WINDSHIELD WIPER OPERATION
CHECK WINDSHIELD WASHER OPERATION (IF APP.)
CHECK THROTTLE OPERATION
CHECK HORN(S) OPERATION
CHECK AIR SYSTEM – MINIMUM 120 PSI, MAXIMUM 130 PSI
CHECK AIR SYSTEM FOR LEAK DOWN
CHECK OPERATION OF BACK UP ALARM
CHECK HVAC SYSTEM
BLOWER MOTOR OPERATION
TEMPERATURE CONTROL
DEFROSTER OPERATION
A/C OPERATION (IF APP.)
AUXILIARY FAN(S) (IF APP.)
TH
CHECK 5 WHEEL UNLATCH CONTROL
CHECK OPERATION OF BOOM
CHECK OPERATION OF WINDOWS
CHECK SEAT BELT SYSTEM PER 10-STEP INSPECTION
CHECK OPERATION OF DOOR LATCHES
CHECK DOME LIGHT OPERATION
CHECK ALL GLASS AND MIRRORS
CHECK FIRE EXTINGUISHER CHARGE (IF APP.)
CAB DOWN – EXTERIOR
CHECK SIDE DOOR HINGE (IFF APP.)
CHECK CAB ACCESS STEPS AND HANDLES
CLEAN HEATER / AC FILTER (IF APP.)
CHECK REAR DOOR ROLLERS / SLIDE ADJUSTMENT
CHECK GLADHAND SEALS AND TRAILER AIR LINES
CHECK TRAILER LIGHT CORD
CHECK HEADLIGHTS / MARKER LIGHTS
CHECK TURN SIGNALS
CHECK STROBE LIGHT (IF APP.)
CHECK SPOTLIGHTS
CHECK WIPER BLADES
CHECK WINDSHIELD WASHER FLUID LEVEL
CHECK TRANSMISSION FLUID LEVEL
CHECK ENGINE OIL LEVEL
CAB UP
CHECK OPERATION OF CAB TILT PUMP
CHECK CAB SAFETY PROP
CHECK CAB SUSPENSION AND LATCH
CHECK INTAKE DUCTING FOR LEAKS
CHECK RADIATOR FOR LEAKS
CHECK RADIATOR MOUNTS
CHECK COOLANT LEVEL AND CONCENTRATION
CHECK AND ADJUST COOLANT ADDITIVE (IF APP.)
CHANGE ENGINE COOLANT
CHECK COOLANT HOSES AND CLAMPS
CHECK FAN CLUTCH FOR OPERATION (IF APP.)
CHECK ENGINE COOLING FAN FOR CRACKS
CHECK ENGINE BELT(S) AND TENSIONER
CHANGE ENGINE COOLANT FILTER (IF APP.)
CHECK ENGINE AND TRANSMISSION FOR LEAKS
DRAIN FUEL WATER SEPARATOR
CHANGE FUEL FILTER / FUEL WATER SEPARATOR
CHECK AIR RESTRICTION GAUGE (IF APP.)
CHANGE AIR FILTER
CHANGE AIR DRYER DESICCANT (IF APP.)
CHECK EXHAUST SYSTEM
CLEAN TRANSMISSION BREATHER
50
TECHNICIAN
0 = ADJUSTMENT NECESSARY
A B C D
UNDER VEHICLE
CHECK STEERING GEAR
CHECK BRAKE LININGS AND DRUMS
CHECK SPRINGS
CHECK SHOCK ABSORBERS (IF APP.)
TORQUE FRONT AXLE MOUNTING BOLTS
TORQUE FRONT AXLE KING PIN DRAW KEY NUT(S)
CHECK POWER STEERING PUMP
CHECK STARTER MOUNTING AND CONNECTIONS
CHECK ENGINE AND TRANSMISSION FOR LEAKS
CHANGE ENGINE OIL AND FILTER
CHANGE TRANSMISSION FILTERS
CHANGE TRANSMISSION FLUID
CHECK ENGINE AND TRANSMISSION MOUNTS
CHECK WHEEL SEALS FOR LEAKS
CLEAN REAR AXLE BREATHER
CHECK DIFFERENTIAL FOR LEAKS
CHECK DIFFERENTIAL OIL LEVEL
CHANGE DIFFERENTIAL OIL
CHECK LIFT CYLINDERS FOR LEAKS
TORQUE REAR AXLE MOUNTING BOLTS
CHASSIS
CHECK FRONT WHEEL BEARINGS
CHECK FRONT AXLE OIL LEVEL (IF APP.)
REPACK FRONT WHEEL BEARINGS (IF APP.)
CHECK BATTERY CABLES & HOLDDOWNS
CHECK BATTERIES FOR CRACKS OR DAMAGE
CLEAN BATTERY CABLE CONNECTIONS
CHECK BATTERY BOX COVER HOLDDOWNS
DRAIN WATER FROM AIR TANKS
CHECK AND TORQUE ALL WHEEL NUTS
CHECK WHEELS
CHECK TIRE AIR PRESSURE, TREAD DEPTH & CONDITION
CHECK REAR AXLE PLANETARY FLUID LEVEL (IF APP.)
INSPECT PLATFORMS
CHECK FRAME FOR CRACKS
CHECK MUD FLAPS / FENDERS (IF APP.)
CHANGE HYDRAULIC SYSTEM FILTER
CHECK HYDRAULIC FLUID LEVEL
CHANGE HYDRAULIC FLUID
CLEAN HYDRAULIC TANK VENT
CHECK CAB HINGE PINS AND BUSHINGS
LUBRICATION
CHECK / LUBRICATE REAR DOOR ROLLERS
CHECK / LUBRICATE STEERING SLIP JOINT
CHECK / LUBRICATE STEERING U-JOINTS
CHECK / LUBRICATE ALL STEERING LUBE POINTS
CHECK / LUBRICATE SLACK ADJUSTERS
CHECK / LUBRICATE DRIVELINE U-JOINTS
CLEAN, CHECK, ADJUST AND LUBE 5
CHECK AND LUBRICATE 5
CHECK AND LUBRICATE 5
CHECK AND LUBRICATE BOOM PIVOT BEARINGS
CHECK AND LUBE BOOM CYLINDER BEARING
ADD GREASE TO AUTOLUBE RESERVOIR (IF APP.)
TEST DRIVE
DRIVE VEHICLE TO CHECK FOR OVERALL OPERATION
AS NEEDED
AS NEEDED
6 Scheduled Maintenance
HOURS
Χ = REPAIRS NEEDED.
OPERATION
TH
WHEEL JAWS
TH
WHEEL TOP PLATE
TH
WHEEL PIVOT PINS
DATE
A B C D