Char-Broil 18402082 Guía De Producto página 5

CAUTION
SPIDER ALERT!
SPIDER AND WEBS
INSIDE BURNER
If your appliance is getting hard to light or the flame is
weak, check and clean the venturi's and burners.
Spiders or small insects are know to create
"flashback" problems by building nests and laying
eggs in the appliance venturi or burner obstructing the
flow of gas. The back-up gas can ignite behind the
control panel. This flashback can damage your
appliance and cause injury. To prevent flashbacks
and ensure good performance the burner and venturi
tube assembly should be removed and cleaned when
ever the appliance has been idle for an extended
period of time.
General Grill Cleaning
Do not mistake brown or black accumulation of grease
and smoke for paint. Interiors of gas grills are not painted
at the factory (and should never be painted). Apply a
strong solution of detergent and water or use a grill
cleaner with scrub brush on insides of grill lid and bottom.
Rinse and allow to completely air dry. Do not apply a
caustic grill/oven cleaner to painted surfaces.
Lighting Instructions
1. Read all instructions before lighting.
2. Open or remove lid during lighting.
3. Push and turn knob on regulator/valve to HIGH position.
4. Push igniter button rapidly.
5. If ignition does not occur in 5 seconds, turn the
regulator/valve knob OFF, wait 5 minutes, and repeat the
lighting procedure.
Match Lighting Instructions
Important! Remove or raise lid and cooking grate to open
position.
Attempting to light burner with lid closed may cause an
explosion. Do not expose any part of your body or clothing
directly above cooking area when lighting.
NOTE: remove cooking grate, then replace when complete.
1. Place lighted wooden match under the heat tent, neat the
burner.
2. While holding match in place, turn control knob to lighting
position. Grill will ignite.
3. Observe burner flames under the heat tent.
Make sure burner ignites and stays lit on both sides.
4. Preheat grill for 6 minutes with lid closed. Using control
knob on Regulator/Valve, adjust flame to desired height for
cooking.
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner control OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Burner Flame Check
Light burner. Make sure burner stays lit while rotating the
control knob from HIGH to LOW. Always check flame prior
to each use.
High
Low
5