Product Overview - Cramer 2903286 Manual De Instrucciones

Product Overview

EN
Your machine has been engineered and manufactured to high standard for
dependability, ease of operation, and operator safety. When properly cared for, it
will give you years of trouble-free performance.
Know your pole saw head
1 Pole saw head
2 Chain cover lock nut
3 Oil tank
4 Bar
5 Chain
6 Scabbard
7
Knob
Assembly
Insatll the pole saw head
1
Remove the rubber protector.
2
Loosen the knob on the coupler.
3
Push in the release button located on the lower shaft. Align the release
button with the positioning hole and slide the two shafts together. Rotate
the lower shaft until the button locks into the positioning hole.
4 Tighten the knob securely.
Operation
Adding bar and chain lubricant
2
cramer.eu
8 Release button
9 Cutters
10 Cutters chain rotation
11 Drive links
12 Bar groove
13 Chain adjustment screw
(see Figure 2)
(see Figure 3)
Use Bar and Chain Lubricant. It is designed for chains and chain oilers, and is
formulated to perform over a wide temperature range with no dilution required.
NOTE: Pole saw comes from the factory with no bar and chain lubricant added.
Level should also be checked after every 20 minutes of use and refilled as needed.
1 Unscrew and remove the cap from the oil tank.
2 Pour oil in the tank and monitor the level on the indicator.
3 Make sure no impurities penetrate the oil tank when filling.
4 Screw on the oil cap and tighten it.
NOTE: Do not use dirty, used or otherwise contaminated oils. Damage may occur
to the bar or chain.
NOTE: It is normal for oil to seep from the saw when not in use. To prevent
seepage, empty the oil tank after each use then run for one minute. When storing
the unit for a long period of time (three months or longer) be sure the chain is
lightly lubricated; this will prevent rust on the chain and bar sprocket.
Preparation for cutting
• Wear non-slip gloves for maximum grip and protection.
•
Maintain a proper grip on the unit whenever the motor is running. Use your
right hand to firmly grip the rear handle while your left hand has a firm grip
on the pole shaft.
• Hold unit firmly with both hands. Always keep your left hand on the pole
shaft and your right hand on the rear handle, so your body is to the left of
the chain line. Never use a left-handed (cross-handed) grip, or any stance
that places your body or arm across the chain line.
•
Never stand directly under the limb you are cutting.
•
Be certain the collars are fully tightened before operating equipment; check
them periodically for tightness during use to avoid serious injury.
Work techniques
(see Figure 4)
Delimbing a tree