Troubleshooting; Technical Data - Cramer 2903286 Manual De Instrucciones

Cleaning
EN
Cleaning the machine and the motor
After every work session, clean the machine thoroughly to remove all dust and
debris.
•
To reduce fire hazards, keep the machine and, in particular, the motor free
of leaves, branches or excessive grease.
• Always clean the machine after use with a damp cloth dipped in neutral
detergent.
•
Remove all traces of moisture using a soft damp cloth. Moisture can
generate risks of electric shocks.
• Do not use aggressive detergents or solvents to clean the plastic parts or
handgrips.
•
Do not spray water onto the motor and electrical components and prevent
them from getting wet.
• To avoid overheating and damage to the motor or the battery, always keep
the cooling air vents clean and free of debris.
Cleaning the chain
Remove any traces of sawdust or oil deposits from the chain every time it is
used.
If there is excessive dirt or resin build-up, disassemble the chain and place it
in a container with a specific cleanser for a few hours. Then rinse it with clean
water and treat it with a suitable anticorrosive spray, before reassembling on the
machine.

Troubleshooting

PROBLEM PROBABLE CAUSE
The poles are not assembled
Pole saw
correctly.
fails to
operate.
4
cramer.eu
POSSIBLE SOLUTION *
Reassemble the poles according
to the instructions.
No oil in the oil tank.
The discharge port is blocked
by debris.
Bar and Inlet opening in inner oil tank
chain
is blocked by debris.
running
The sprocket is stuck and
hot and
clogged with debris.
smoking.
Chain tension for
overtightened or loose
condition.
Dull chain.
The chain
does not
Chain on backwards.
cut.
Lack of bar and chain
Motor
lubricant can cause
running,
increased friction. Chain
but cutting
needs to be properly
abnormal
maintained.
* If the fault is not solved, you must go to your distributor and/or nearest Authorized
Technical Service.

Technical Data

PROPERTY
10'' (254 mm)
Guide bar length
Refill oil into the oil tank.
Refer to the manual to remove
the bar and clean out the debris.
Clean the oil tank, and refill with
clean bar and chain lubricant.
Clean the sprocket and refill with
clean bar and chain lubricant.
Refer to Re-tensioning the saw
chain in the manual.
Sharpen or replace the chain.
Refer to Replacing the Bar and
Chain assembly earlier in this
manual.
Make sure the pole saw always
has bar and chain lubricant.
VALUE