Description; Purpose; Overview; General Power Tool Safety Warnings - Cramer A48T10PS-CR Manual Del Usuario

EN
1

DESCRIPTION

1.1

PURPOSE

The pole saw attachment mounted on a pole to enable the
operator to cut the branches of standing trees. It is not
intended for cutting fire wood or logs like with a normal
chainsaw.
This appliance is not intended for use by persons (including
children) with reduced understanding, or lack of experience
and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
1.2

OVERVIEW

Figure 1-13.
Pole saw head
1
Chain cover lock nut
2
Oil tank cap
3
Bar
4
Chain
5
Scabbard
6
Wing knob
7
Release button
8
2 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3

INSTALLATION

3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
Cutters
9
10 Cutters chain rotation
11 Drive links
12 Bar groove
13 Chain adjustment
screw
14 Coupler
15 Positioning hole
WARNING
WARNING
English
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
3.2 ADD THE BAR AND CHAIN
LUBRICANT
Examine the amount of oil in the machine. If the oil level is
low, add the bar and chain lubricant as follows.
Use bar and chain lubricant that is only for chains and chain
oilers.
The machine comes from the factory without bar and chain
lubricant.
1. Loosen and remove the cap from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt enters
in the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. A completely filled oil tank will last for 15 - 40 minutes
operating time.
Do not use dirty, used or contaminated oil. Damage can
occur to the bar or chain.
3.3

INSTALL THE ATTACHMENT

Figure 2.
1. Remove the rubber protector.
2. Loosen the knob on the coupler.
3. Push in the release button located on the lower shaft.
Align the release button with the positioning hole and
slide the two shafts together. Rotate the lower shaft until
the button locks into the positioning hole.
4. Tighten the knob securely.
4
WARNING
IMPORTANT
NOTE
IMPORTANT