Tabla De Contenido; Safety Giudelines - Siemens 1PM6 Manual De Instrucciones

Contents
Safety Giudelines ........................................................... 2
1 Basic requirements ....................................................... 3
2 Product information ...................................................... 3
2.1 Application range ............................................................. 3
2.2 Technical parameters ...................................................... 3
2.3 Mode of operation and design ......................................... 3
2.4 Transport, Storage ........................................................... 3

Safety Giudelines

This manual contains notes which you should observe to ensure your own personal safety, as well to protect the product and connected
equipment. These notices are highlighted in the manual by a warning triangle and are marked as follows to the level of danger.
G E F A H R
DANGER
DANGER
Symbol
Note on hazardous situation
WARNING
Symbol
Warning note
CAUTION
Symbol
Warning note
CAUTION
Warning note
NOTICE
Qualified Personnel
The device/system may only be set up and operated in conjunction with this manual. Only qualified personnel should be allowed to install
and work on the this equipment. Qualified persons are defined as persons who are authorized to commission, to ground, and to bag
circuits, equipment, and systems in accordance with established safety practices and standards.
Warning
This device and its components may only be used for the applications described in the catalogue or technical description, and only in
connection with devices or components from other manufacturers which have been approved or recommended by Siemens.
This product can only function correctly and safely if it is transported, stored, set up, and installed correctly, and operated and maintained
as recommended.
Copyright Siemens AG 2005 All rights reserved
The reproduction, transmission or use of this document or its
contents is not permitted without express written authority.
Offenders will be liable for damages. All rights, including rights
created by patent grant or registration of a utility model or design,
are reserved.
Siemens AG
Automation Group
Motion Control Systeme (MC)
D-97615 Bad Neustadt / Saale
2
Page
Note
ENGLISH
3 Fitting the motor ............................................................ 4
3.1 Basic requirements .......................................................... 4
3.2 Immited vibrations, output elements ............................... 4
3.3 Electrical connections ...................................................... 5
4 Start-up ........................................................................... 5
5 Repair .............................................................................. 5
5.1 Temperature sensor ........................................................ 5
5.2 Disassembly, assembly of gear encoder GEL 244 ......... 5
5.3 Changing bearings, lubrication ........................................ 6
Annex ...................................................................................... 27
DANGER
indicates an imminently hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING
indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION
used with the safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in minor or moderate
injury.
CAUTION
used without safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in property damage.
NOTICE
NOTICE used without safety alert symbol indicates a potential
situation which, if not avoided, may result in an undesirable result
or state.
Disclaimer of Liability
We have checked the contents of this manual for agreement with
hardware and software described. Since deviations cannot be
precluded entirely, we cannot guarantee full agreement. However,
the data in the manual are reviewed regularly and any necessary
corrections included in subsequent editions. Suggestions for
improvement are welcomed.
© Siemens AG 2005
Technical data subject to change.
Siemens AG