Storing And Caring For The Product; Troubleshooting - Imetec ECO EXTREME SILENCE Instrucciones Para El Uso

REPLACING THE OUTLET AIR FILTER (16)
• Press the interlock of the outlet filter grille (7) and remove the outlet filter (16). Replace
it with a new one [Fig. G4].
• Refit the outlet filter grille (7) and snap the interlock in place.

STORING AND CARING FOR THE PRODUCT

The combined brush (4) can be hooked in the relative seat [17A or 17B] when the vacuum
cleaner is in the parking position [P - horizontal (F2) or vertical (F3)].
PROBLEM
The appliance does
not go on.
The appliance turns
off during use and
does not turn on
again.
The vacuum cleaner
does not suction well.
The clogged filter
indicator is on.
The dust collection
system does not
close correctly.

TROUBLESHOOTING

• Ensure that the plug is connected to the socket.
• Make sure the on/oFF button has been pressed
• The vacuum cleaner is equipped with a protective
motor thermostat that shuts off the appliance in the
event of overheating! (caused by obstructing objects or
a clogged dust collection system).
• If triggered, switch the appliance off by pressing the
ON/OFF switch
socket and let it cool down completely for a few hours.
• Remove any dust or the obstructing object before
restarting the appliance.
• Electronic power control set to the minimum: Increase
the power to Medium or Max.
• The dust collection system (15) is full: clean the dust
compartment (15A).
• The filter is clogged: clean or replace the filter.
• The dust collection system (15) is full: empty the dust
collection compartment (15A).
• The filter is clogged: clean or replace the filter.
• The clogged filter LED (20) can even light up if the
power decreases, caused by an object that is too big
clogging the suction pipes: switch the appliance off,
disconnect the plug from the socket and remove the
object from the vacuum cleaner.
• A crevice tool is being used: reduce suction from the
electronic power control.
• A safety device does not allow the dust collection
system to be inserted if the Hepa filter (15D) is missing.
• Make sure the Hepa filter is present (15D) and it is
fitted correctly.
SOLUTION
, disconnect the plug from the
EN
.
15