Maintenance; Storage - Powermate PWFC132600 Manual De Operación

MAINTENANCE

• SAVE ALL INSTRUCTIONS
W A R N I N G
RISK OF BURN HAZARD.
ing maintenance, you may be exposed to hot surfaces, water
pressure or moving parts that can cause serious injury or death.
W A R N I N G
RISK OF FIRE HAZARD.
nect, spark plug wire, let the engine cool and release all water
pressure before performing any maintenance or repair. The
engine contains fl ammable fuel. Do not smoke or work near open
fl ames while performing maintenance.
To ensure effi cient operation and longer life of your pressure washer, a
routine maintenance schedule should be prepared and followed. If the
pressure washer is used in unusual conditions, such as high-temper-
atures or dusty conditions, more frequent maintenance checks will be
required.
ENGINE
Consult the Engine Owners Manual for the manufacturer's recommen-
dations for any and all maintenance.
PUMP
The pump is supplied with the correct amount of oil and does not
require further service. If there is a problem with the pump, contact
an Authorized Service Center.
NOZZLE CLEANING
If the nozzle becomes clogged with foreign materials, such as dirt, ex-
cessive pressure may develop. If the nozzle becomes partially clogged
or restricted, the pump pressure will pulsate. Clean the nozzle immedi-
ately using the nozzle kit supplied and the following instructions:
1. Shut off the pressure washer and turn off the water supply.
2. Pull trigger on gun handle to relieve any water pressure.
3. Remove quick connect nozzle from the spray wand.
4. Remove any obstructions from the quick connect nozzle with the
nozzle cleaning tool provided and fl ush with clean water.
5. Re-attach the quick connect nozzle to the spray wand and turn on
the water supply.
6. Start pressure washer and test.
HOW TO CLEAN THE WATER
INLET FILTER
This screen fi lter should be checked periodically and cleaned if neces-
sary.
1. Remove fi lter by grasping end and
removing it from water inlet of pump as
shown. (Fig. 11)
2. Clean fi lter by fl ushing it with water on
both sides.
3. Re-insert fi lter into water inlet of pump.
NOTE: Cone side faces out.
NOTE: Do not operate pressure washer without fi lter properly installed.
200-2835

STORAGE

When perform-
• SAVE ALL INSTRUCTIONS
ENGINE
Consult the Engine Owners Manual for the manufacturer's
Always discon-
recommendations for storage.
PUMP
The manufacturer recommends using a pump protector/winterizer
when storing the unit for more than 30 days and/or when freezing tem-
peratures are expected. If a pump protector/winterizer is not available,
RV antifreeze or windshield washer fl uid needs to be run through the
pump as outlined in the steps below.
NOTE: Using a pump protector/ winterizer, RV antifreeze or windshield
washer fl uid is to provide proper lubrication to the internal seals of the
pump regardless of temperature or environment.
1. Obtain a funnel, 6 oz. of RV antifreeze or windshield washer fl uid,
and 16–36" of garden hose with a male hose connector attached to
one end.
C AU TION
RV antifreeze. Any other antifreeze is corrosive and can damage
pump.
2. Disconnect spark plug wire.
3. Connect length of garden hose to water inlet of pump.
4. Add RV antifreeze or windshield washer fl uid to hose
as shown. (Fig. 12)
5. Pull engine starter rope slowly several times until antifreeze/
washer fl uid comes out of high-pressure hose connection of pump.
6. Remove garden hose from water inlet of pump.
7. Reconnect spark plug wire.
H
FIG. 11
11 - ENG
RISK OF PROPERTY DAMAGE.
Copyright © 2011 MAT Industries, LLC
Use only
FIG. 12