Tabla de contenido
Idiomas disponibles
Idiomas disponibles
UNPACKING
AND REMOVING
SHiPPiNG
BOLTS
When removing the washer from the carton base, be sure
to remove the foam drum support in the middle of the
carton base. See drawing
below.
If you must lay the washer down to remove the base
packaging
materials, always protect the side of the
washer and lay it carefully
on its side. DO NOT lay the
washer on its front or back.
To prevent internal damage
during transport, the washer
is equipped
with four shipping bolts and plastic retainers.
IMPORTANT:
*These shipping bolts and retainers MUST NOT be
removed until just before moving the washer into its
final position.
*These bolts and retainers MUST be removed before
operating
the washer.
*Failure to remove shipping
bolts and retainers may
cause severe vibration
and noise, which can lead to
permanent
damage
to the washer.
NOTE: The power cord is secured to the back of the
washer with a shipping bolt to help prevent operation
with shipping bolts in place.
FoamTub
Support
Carton
Base
E
Shipping
Bolts
Power
Cord
i
1. Starting with the bottom
two shipping
bolts, use the
wrench (included)
to futty loosen ail four shipping
bolts by turning them counterclockwise.
Shipping
Bolts
2. Remove the bolt assemblies by wiggling
them
slightly while pulling.
3. Locate the four hole caps included
in the accessory
pack and install them in the shipping
bolt holes.
NOTE: Save the bolt assemblies for future use. To prevent
damage
to internal components,
DO NOT transport the
washer without
reinstalling the shipping bolts.
Tabla de contenido
