Tabla de contenido
Idiomas disponibles
Idiomas disponibles
12
Step 12
Attach canopy (#3) to the
mounting bracket by placing
screws (S2) into slot in
canopy. Twist clockwise to
lock into place. Tighten screws
firmly.
13
For blade assembly, position blade holder (#6), blade (#5) and blade
ornaments (#10) so that all screw holes are aligned (as shown in figure
below). Using blade screws (S5), insert through top of blade holder,
through blade, and into blade ornament. Tighten securely.
Blade Holder
Screws (S6)
CAUTION: Install blade holders to motor only after motor installation is
complete. This will prevent damage to the blade holders which have been
carefully balanced. IMPORTANT: Remove rubber cushions, saving motor screws
for installation.
CAUTION
To reduce the risk of personal injury, DO NOT bend the blade arms when
installing them. When balancing the blades, or cleaning the fan, do not insert
foreign objects in between rotating fan blades.
Ceiling
Canopy (3)
Screws (S2)
Bottom of Canopy
Step 13
Blade Holder (6)
Blade Screws (S5)
Blade (5)
Blade Ornament (10)
14
5 Blade Installation
Remove rubber cushions,
saving motor screws for
blade installation. Using
motor screws (S5) provided,
line up holes from the blade
arm with the holes in the
motor housing. Tighten
screws securely.
15
1. To install the Switch Housing Assembly (#9), locate both modular
wiring plugs (A) and (B). One extends from the mounting plate (E) on
bottom of fan body and one extends from the Switch Housing (#9). Align
the two plugs so the latch on the side of the plugs will engage when
pushed together. Push the two plugs firmly together until latched.
2. Loosen 2 of the 3 screws (F) on mounting plate. Completely remove
one of the screws. Raise switch housing (#9) and align the mounting slots
(D) in the switch housing with the mounting screws (F) on the mounting
plate on bottom of fan body. Rotate the switch housing to the right until
the two screws are completely seated into mounting slots. Replace screw
that was removed. Tighten the three mounting screws securely.
IMPORTANT: Be sure that no wires are caught in mounting slots or pinched between
switch housing and mounting plate.
Screws (F)
Mounting Slots (D)
Step 14
Step 15
Mounting Plate (E)
Modular Wiring Plug (A)
Modular Wiring Plug (B)
Switch Housing (9)
Tabla de contenido
