Getting Started - KERN CGB Serie Instrucciones De Funcionamiento

Getting Started

Guarantee
The guarantee shall expire in the event
that
– the directions in the operating instructions
are not followed properly
– the device is used for applications
beyond those described in these
operating instructions
– the device is altered or opened
– the device is mechanically damaged or
is damaged due to exposure to media
and/or liquids
– normal wear of the device has occured
– the device has not been adequately set
up or its electrical installation is incorrect
– the measuring equipment is overloaded
Storage and Shipping Conditions
Do not expose the balance to shock,
vibration, moisture or extreme
temperature.
Unpacking the Balance
§ After unpacking the balance, check it
immediately for any visible damage
$ If you see any sign of damage, proceed
as directed in the chapter entitled "Care
and Maintenance" under the section on
"Safety Inspection"
Save the box and all parts of the
packaging until you have successfully
installed your balance. Only the original
packaging provides the best protection
for shipment. Before packing your
balance, unplug all connected cables
to prevent damage.
40
Equipment Supplied
The equipment supplied includes the
components listed below:
– Balance with weighing pan mounted
in place
– Plug-in AC adapter
– Operating instructions
Installation Instructions
CGB balances are designed to provide
reliable weighing results under normal
ambient conditions. When choosing a
location to set up your balance, observe
the following so that you will be able to
work with added speed and accuracy:
– Set up the balance on a stable, even
surface
– Avoid placing the balance next
to a heater or exposing the balance
to direct sunlight
– Protect the balance from direct drafts that
come from open windows or doors
– Avoid exposing the balance to strong
vibration during weighing
– Protect the balance from aggressive
chemical vapors
– Avoid exposing the balance to extreme
moisture
Conditioning the Balance:
Moisture in the air can condense on
the surfaces of a cold balance whenever
it is brought into a substantially warmer
place. Therefore, condition a cold
balance for approx. 2 hours at room
temperature, leaving it unplugged from
AC power. Afterwards, keep the
balance continuously connected to
AC power.