Emerson Duo CF560BS00 Manual Del Propietário página 19

7. Wall Control Installation
WARNING
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
7.8
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to install the
Ceiling Fan Wall Control into the Outlet Box.
Screw Wall Control into Wall Box using the supplied
screws. Leave Wall Control in "OFF" mode until fan
installation is completed.
Install the second Wall Control (sold separately) into the
Wall Box containing the "Load" Wire. Connect the Wall
Control Black Wire with the Yellow Label marked
"To Power Supply" to the Traveler Wire from the first Wall
Box. Securely connect Wires with Wire Connector
(supplied) (Figure 24).
Connect the Wall Control Black Wire with the Blue Label
marked "To Fan" to the "Load" Black Wire in the Wall Box.
Securely connect Wires with Wire Connector (supplied)
(Figure 24).
Connect the Wall Control Green Ground Wire to the Bare Copper Wire or Green Ground Wire in the Wall Box.
Securely connect Wires with Wire Connector (supplied)
(Figure 24).
The Wall Control is supplied with a White, Ivory, and
Almond color Switch Covers. Choose the finish that best
suits your needs and snap the Cover onto the Wall
Control.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
(Continued)
3-WAY WIRING DIAGRAM:
NOTE: Retrofit 3-way installations are likely to include
two traveler wires between the two wall boxes. In new
construction, only one traveler wire Is required (See
Figure 23).
STANDARD WIRING FOR EXISTING
3-WAY CONTROLS
HOT BLK
3-WAY WIRING DIAGRAM: RETROFIT
HOT BLK
BLK
GND
FAN/LIGHT
WALL
CONTROL
Figure 24
Please contact 1-800-654-3545 for further assistance
19
EXISTING
WALL CONTROL
TRAVELER WIRES
BLK
BLK
GROUND
TRAVELER
WIRES FAN/LIGHT
WALL
CONTROL
SECOND WALL CONTROL
PURCHASED
SEPARATELY
emersonfans.com
U.L. Model No.: CF560
LOAD
LOAD