Metabo HPT C 12FDHB Instrucciones De Seguridad Y Manual De Instrucciones página 33

8 mm bolt
6 mm hex.
bar wrench
Loosen
Fig. 37-c
WARNING:
CAUTION:
2. Mounting the saw blade
WARNING:
(1) Install a 12" (305 mm) blade with arbor, making sure the rotation arrow on the blade
matches the clockwise rotation arrow on the gear case, and the blade teeth are
pointing downward.
(2) Place washer (B) against the blade. Thread the 8 mm bolt on arbor in a counterclockwise
direction.
NOTE:
Make sure the fl ats of the washer (A)/(B) is engaged with the fl ats on the
spindle. Also, the fl at side of the washer (A)/(B) must be placed against
the blade.
(3) Place the 6 mm hex. bar wrench spanner on the 8 mm bolt.
(4) Press the spindle lock, holding it in fi rmly while turning the blade counterclockwise.
When it engages, continue to press the spindle lock in, while tightening the 8 mm bolt
securely.
(5) Rotate the cover plate (A) back to its original position until the slot in the cover plate (A)
engages with the hole of cover plate screw.
While holding the lower guard at the uppermost position, tighten the cover plate screw
with a Phillips screwdriver.
(6) Lower the lower guard and verify that operation of the guard does not bind or stick.
(7) Be sure the spindle lock is released so the blade turns freely.
CAUTION:
Washer (B)
Tighten
When mounting the saw blade, confi rm that the rotation indicator
mark on the saw blade and the rotation direction of the gear case
(Fig. 1) are properly matched.
* Confi rm that the spindle lock has returned to the retract position
after installing or removing the saw blade.
* Tighten the 8 mm bolt so it does not come loose during operation.
Confi rm the 8 mm bolt has been properly tightened before the
power tool is started.
Unplug the miter saw before changing/installing the blade.
Never attempt to install saw blades larger than 12" (305 mm) in
diameter.
Always install saw blades that are 12" (305 mm) in diameter or less.
Washer (B)
Saw Blade
Bolt
Fig. 37-d
English
Washer (A)
Spindle
33