Using Your Cocoa Grande - Back to Basics COCOA GRANDE Manual De Instrucciones

CONTROL BUTTONS:
HEAT & HI SPEED - Mixes and heats your drink at high speed. High
speed is perfect for creating frothy drinks.
HEAT & LO SPEED - Mixes and heats your drink at low speed. Low
speed is perfect for drinks that don't need froth.
CANCEL - Stops any function. "CANCEL" can be pressed at any
point in the cycle to turn the appliance off. Buttons will flash red to
indicate that the appliance is still plugged in.
FROTH & DISPENSE - Stirs your drink at a high speed, without
adding heat, to mix and froth your drink for serving.
Note: After a button has been pressed to make a selection, the
indicator light will glow blue.
The measurements used below produce 60 ounces. Refer to the
Ingredients Chart to determine usage for alternate serving sizes.
1. Place mixing container on to the motor base.
2. Pour 60 ounces of water or milk into the mixing container.
Note: Do not fill the mixing container past the 60 ounce "Max
Fill" line.
3. Add 1 cup of your favorite instant mix.
4. Place the lid on to the mixing container, making sure that the lid covers the pour
spout.
5. Plug the Cocoa Grande™ into a 120 volt, AC outlet only.
6. Press the "HEAT & HI SPEED" or "HEAT & LO SPEED" button. The selected
control button will glow blue and your Cocoa Grande™ will begin to mix and
heat. When the beverage reaches the "Perfect Temperature," the appliance will
automatically go idle. As the beverage cools down, the appliance will
automatically reheat and remix back to the "Perfect Temperature." The
appliance will remain on until "CANCEL" is pressed. "CANCEL" may be used at
any time to turn the appliance off. The control lights will flash red until the
appliance is unplugged or a selection is made. Selecting another speed setting
will change the operation and the selected control button will glow blue. Note: A
full 60 ounces takes approximately 13 minutes to reach the "Perfect
Temperature."
7. Once the appliance automatically goes idle, place a cup underneath the
dispensing valve and press the "FROTH & DISPENSE" button. This setting will
mix the beverage while you dispense so that a rich layer of froth is dispensed
into your cup along with the hot drink.
8. Press down on the dispensing valve lever to dispense the hot drink into your cup
while the motor is mixing the beverage. After dispensing the beverage, select
HEAT & HI SPEED" or "HEAT & LO SPEED" if there is still liquid in the mixing
container or press the "CANCEL" button if less than 1 cup of beverage remains.
9. When the container has less than 1 cup of liquid remaining or is empty, press
the "CANCEL" button. Note: The appliance will remain on until you press
"CANCEL." The control buttons will continue to flash red after "CANCEL" has
been pressed, indicating that the appliance is plugged in, but not in operation.
U Y
SING OUR
C G
OCOA RANDE
4
™