Copying The Id Code To An Extra Handset - Marmitek DOORPHONE 120 Modo De Empleo

If after you have logged on and you hear interference coming from other wireless devices in
the neighbourhood, such as a mobile phone, then repeat the above mentioned procedure or
switch over to another channel (when you change the channels, you will need to repeat the
pairing procedure).
When the pairing has not been successful (the 'P' symbol on the LCD screen will flicker),
then put off the handset and disconnect the power supply of the door unit by removing the
batteries. Repeat the pairing procedure.

4.1 Copying the ID code to an extra handset:

Beware! In case you have more than one handset, always first perform the pairing procedure
with one handset only. Use the logged-on handset to copy ('clone') the ID to the extra
handset(s). Every time you add an extra unit to the system, you need to copy the ID code to it;
otherwise the system will not function properly.
Follow the steps given below to copy the ID code onto an extra handset.
Make sure that the extra ('Slave') handset has been switched to the same channel as the primary
('Master') handset (see chapter 3.2:'Channel settings handset'). Tip! All 'Slave' handsets can be
cloned to the 'Master' handset at the same time.
Logged-on handset 'Master'
Step 1
Press and hold the buttons (8) and (9)
at the same time for a few seconds
to put on the handset. You will now
hear a short beep. Release (8) and (9)
buttons and you will hear a 2nd beep
as confirmation. You will see a 'P'
flashing in the display.
Step 2
Press on the call button (10) a
symbol will appear on the
display. The saved ID code is
now being sent.
Step 3
Now press briefly on the on/off
button (8) to return to the normal
display.
To activate the temperature reading, the batteries need to be removed from the door unit for
the duration of 5 seconds.
10
To be cloned handset 'Slave'
Step 1b
Press and hold the buttons (8) and (9)
at the same time for a few seconds
to put on the handset. You will now
hear a short beep. Release (8) and (9)
buttons and you will hear a 2nd beep
as confirmation. You will see a 'P'
flashing in the display.
Step 2b
The 'P' shall stop flashing within
5 seconds after the 'Slave' handset
has received the ID code, and will
beep twice briefly to indicate that
the cloning has been completed.
Step 3b
Now press briefly on the on/off
button (8) to return to the normal
display.
© MARMITEK