Pairing The Handset And Door Unit - Marmitek DOORPHONE 150 Modo De Empleo

6. Now the unit can be switched on and ready for operation. Taking
out the unit or keeping it placed in the charger stand will cause
no damage to the battery. In the latter case, when the battery is
being consumed and the voltage falls to a certain level, the
charger stand will automatically charge up the battery. The
segments inside the icon
is under charged.
CAUTION: BE SURE THE BATTERY IN THE HANDSET IS A
RECHARGEABLE TYPE BEFORE YOU PLACE IT IN THE CHARGER
STAND, OTHERWISE AN EXPLOSION MAY RESULT.

PAIRING THE HANDSET AND DOOR UNIT

This process is to match the Door Unit with the handset so that they
can communicate with each other and so that no other devices (even
a doorphone of an identical model) can interfere with you or the
receiving of your signal.
The Door Unit and handset are already paired with a factory pre-set
code when they are shipped from the factory. However, we
recommend pairing them again to achieve better privacy and to avoid
a false triggering of a door lock from a nearby doorphone system.
To perform the pairing process, it is necessary to use alkaline batteries
as the power supply in the Door Unit, while the12V DC supply should
be disconnected temporarily.
1. Place the Door Unit and handset close to each other within a
distance of 1m.
2. With the handset in switch off mode, press and hold the Power
ON/OFF button
together for around 3 sec to enter pairing mode. The LCD will
become backlighted and show a flashing letter "
3. Press and hold the pairing button
while installing the alkaline batteries. The call indicator
start flashing after 3 sec, showing that the Door Unit has entered
pairing mode.
Perform the same for the Door Unit that is intended to be used at
the back gate (option, not included).
4. Now release the pairing button
front gate Door Unit (DO NOT press the call button on the back
gate Door Unit.). Two "Di Di" sounds will be heard and at the
same time the letter "
8
will flash in turn whenever the unit
and the door lock open button
at the back of the Door Unit
, press call button
" and (or
".
in case there is a back
© MARMITEK
will
on the