Hunter 90121A Manual Del Propietário página 8

22. Loosen the Blade Assembly
Setscrew so that it does not
protrude into the inside of the
Blade Assembly Sleeve. See Fig-
ure 9.
Blade
Assembly
setscrew
setscrew
Hole
FIGURE 9
23. Slide the Blade Assembly Sleeve
over the Motor Shaft, ensuring
the Blade Assembly Screw is po-
sitioned over the Flat Portion of
the Motor Shaft. See Figure 10.
Tighten the Blade Assembly Set-
screw so that it seats against the
Flat Portion of the Motor Shaft.
gently pull the Blade Assembly
to ensure it is secure on the Mo-
tor Shaft.

aSSembly
ContInued
note: For clarity, the Back Grille
has been removed from Figure 10
Blade
to show the Blade Assembly Sleeve/
Assembly
sleeve
Motor Shaft installation.
24. With the Hunter logo facing for-
FIGURE 10
ward and upright, engage the
tabs on the lower part of the
Front Grille into the rim of the
Back Grille, as shown in Figure
11, arrow 1. Then, move the
top of the Front Grille as shown
in Figure 11, arrow 2, so that
the tab at the top of the Front
Grille snaps under the rim of the
Back Grille.
2
1
FIGURE 11
41973-01 03/08/2006